Auto and Shop Information Practice

Below are Sample ASVAB Auto and Shop Information Practice Practice Questions. Write down your answers as you go along, and once you reach the end of the Auto and Shop Information Practice Practice Test, check your answers with the answer sheet! Good luck!

Auto and Shop Information Practice Practice Questions

  1. A typical car battery uses how many volts?

    1. 220
    2. 110
    3. 12
    4. 24
  2. The following are all components of an automobile’s engine cooling system EXCEPT the
    1. distributor.
    2. thermostat.
    3. pressure cap.
    4. water pump.
  3. In the tire rating “P195/70R14,” the “R” stands for
    1. rim.
    2. rear.
    3. round.
    4. radial.
  4. What would happen if an automobile thermostat were stuck in the closed position?
    1. The vehicle heating system would not work.
    2. The RPM limiter would not engage.
    3. The engine could overheat.
    4. The vehicle would run out of gas.
  5. Why is the sheet metal used to make fuel tanks covered with a lead-tin alloy?
    1. to prevent static electricity buildup
    2. to prevent excessive sloshing of fuel
    3. to lessen vibration
    4. to prevent rusting
  6. The two general classes of lubricant are called
    1. flammable and inflammable.
    2. liquids and solids.
    3. natural and artificial.
    4. oils and greases.
  7. A class c fire should be extinguished using
    1. water.
    2. none of the above.
    3. all of the above.
    4. carbon dioxide.
  8. The automobile engine exhaust gas most lethal if breathed in is
    1. carbon monoxide.
    2. thermocarbons.
    3. dihydrogen monoxide.
    4. nitrous oxide.
  9. When referring to an automobile, the term camber refers to
    1. the drift of the vehicle when driving at speeds above 25 mile per hour.
    2. the compression stroke of the cylinders.
    3. the deflection of the headlights between high and low beam usage.
    4. the outward or inward tilt of a wheel from its centerline.
  10. The term stoichiometric refers to
    1. the ideal oil viscosity for an internal combustion engine.
    2. the ideal internal engine temperature for optimal operation.
    3. the ideal air-fuel mixture for an internal combustion engine.
    4. a method of measurement used by European car manufacturers.
  11. Which of the following is a device used to reduce the toxicity of engine emissions?
    1. catalytic converter
    2. turbocharger
    3. carburetor chamber
    4. fuel injector
  12. Oxyacetylene is a mixture of gases that is used in
    1. welding.
    2. deep sea diving.
    3. natural gas powered vehicles.
    4. lighter-than-air craft.
  13. A saw blade that makes wide, grooved cuts so one piece of wood can fit into the groove of another is a
    1. rabbet.
    2. rip blade.
    3. kerf.
    4. dado blade.
  14. Which power saw has a blade consisting of a continuous band of metal with teeth along one edge, and is used primarily for woodworking and metalworking?
    1. the circular saw
    2. the jigsaw
    3. the band saw
    4. the handsaw

Auto and Shop Information Practice Practice Answer Sheet

When you're ready to view the Auto and Shop Information Practice Answers, hover your mouse over the box below. The answers will then appear for you to check your work.
  1. D
  2. A
  3. C
  4. D
  5. B
  6. A
  7. A
  8. D
  9. C
  10. A
  11. B
  12. D
  13. A
  14. B
  15. A

Hopefully you did well! Keep track of your score and continue through the rest of the ASVAB Practice Tests to see how well you do! Once finished, you will have a better idea of what you need to study before the big test.

Be sure to share your score, and this practice test, with your friends!